All posts by Greg Corby

Uncategorized

THREAD LOCKERS

When it comes to thread lockers, there are books, charts, graphs, mil specs, test reports, and enough data to make your head spin. We keep it simple with a basic selection that seems to meet the needs of most of our customers. Here is what we carry and the manufacturers descriptions of applications. Permatex Medium…

Read More
Uncategorized

KIND WORDS FROM ONE OF OUR CUSTOMERS

Cars, guitars, machine tools, taps, dies, lawn mowers, transmissions, amplifiers, bungee cords, left handed drills. I got an Ibanez made (assembled) in USA Saber Custom guitar fixed in time for a Friday night gig, and the guitar was not dropped off until 2:00 PM. I wish Mark stayed open a little later, but the job…

Read More
Uncategorized

FLEX RATCHETING WRENCHES-New Item

FLEX RATCHETING WRENCHES TORQUE CAPABILITY is 30% greater than ANSI Industrial standard. 72 TEETH: Ratcheting box end needs only 5 degrees swing arc versus 30 degrees for standard box end wrenches. DURABILITY: Quality chrome vanadium steel. Precision heat treated for maximum strength. FLEX HEAD: Tilts up to 180 degrees    

Read More
Uncategorized

CARBIDE BURRS

  New to the world of using Carbide Burrs ???? Here’s a couple of basic guidelines. ­General Use ~ Adjust speeds as needed for optimum performance. Use slower speeds for harder materials. Use higher speeds for cutting with smaller diameter burrs. ~ Do not run above maximum speeds. This can cause premature wear and damage…

Read More